#DELTACO USB 3.0 TO SATA ADAPTER CABLE WITH POWER CORD DRIVER#
You can see the driver on disk management as a partition drive with a letter, usually D for a laptopįrom this point on, you can download a cloning program, usually, cost $50.00 and clone your original HDD into the SDD, it will take about 2 hours for a 250GB HDD to transfer to a 250GB SDD. Hard drive on the windows explorer, if not, then restart the computer it will show up there. After it conclude the formating, around 30 seconds, you will be able to see the new If you need more help regarding the Disk Management, please look online, plenty of websites. So now you can click on the new disk andĬreate a partition, format to NTFS and windows readable, assign a letter for it. I went to the "DISK MANAGEMENT", type it on the windows search bar for Cortana or similar, you will see your older driver, the one on the computer as a primary, disk0 and C, and a second disk without any partition. In order to see the drivcer, it has to have a partition and a letter assigned.įormat the driver to have a partition and letter then format to have an NTFS readable partition. The problem is that the driver is NEW and had no partition, which is good for Xbox-One, but bad for the windows.
When I connect the new interface into any laptop, the laptop emits the USB pluged bip and shows next to the clock that there is a Disk attached to the system, perhaps when I search for it on the explorer I cannot see it. The New disk and interface cable (USB to SATA) is working as evidenced by working on an Xbox One (tested) The new disk is an SSD disk by Kingson 240GB and in perfect working order and NEW The computer is a laptop, the original HD is inside the laptop and it is a 2.5", normal laptop SATA connector with an HDD. Hello, I did solve the problem, and I am posting because I saw many forums with the same issue and nobody was telling the correct way to solve it.
0 kommentar(er)
